Wednesday, 2014-04-16

*** nowen (~nowen@99-174-92-191.lightspeed.tukrga.sbcglobal.net) has joined #wikid13:45
*** TXRH_CJ (d8f800fe@gateway/web/freenode/ip.216.248.0.254) has joined #wikid18:18
TXRH_CJhey Nick18:19
nowenhi18:19
nowenhow's it going?18:19
TXRH_CJhow can we configure Wikid server to be based on the DNS name instead of the IP address?18:19
TXRH_CJRichard was discussing this with you a couple of weeks ago and we were talking about it today18:20
nowenWe can setup a DNS entry in wikidsystems.net and point to either your old IP or an entry in your DNS system18:20
TXRH_CJ1min, sorry18:23
nowennp18:23
TXRH_CJwe currently have 2 IPs for the Wikid server and both will be pointing to the Wikid server18:25
nowenok - we can create two entries.  zeropaddedIP1.wikidsystems.net and zeropaddedIP2.wikidsystems.net18:26
nowenone for each18:26
TXRH_CJwe have a DNS load balancer18:30
TXRH_CJwe need the wikid tokens to work if we have a failure and be to still run as-is in the event of a failure18:31
nowenok - so will you be failing over from one wikid server to another/18:31
nowen>18:31
nowen?18:32
TXRH_CJno, we will have 1 wikid server pointing to 2 IPs, if our level 3 ISP fails our fail over will kick in for other address to run the wikid tokens18:36
nowenahh18:36
TXRH_CJthat is our plan to happen18:36
nowenwell, the tokens will check the IP first and if that fails, it will check DNS.18:37
nowenso, we could have an entry in our DNS pointing to your load balancer.  If the IP works, great.  If it fails, the tokens check our DNS which points them to your load balancer18:39
TXRH_CJso we keep the primary as the IP address and register the 2nd IP address as the DNS?18:39
nowenwould that work?18:39
nowencan your load balance automatically switch to the 2nd IP if the first becomes unresponsive?18:40
TXRH_CJwhat do we need to do on our side for this to work?18:40
nowenhave your load balance automatically switch to the 2nd IP if the first becomes unresponsive18:40
*** AccentureDan (3f7c1664@gateway/web/freenode/ip.63.124.22.100) has joined #wikid18:46
AccentureDanNickkkkkkk18:46
TXRH_CJwell it is a wan load balancer for DNS if we make wikid.txrh.com to go to our server on the LAN, on the wan we have 2 ISPs the DNS load balancer will change DNS when the ISP fails18:46
AccentureDandid you get our PO?18:46
AccentureDanmore importantly, do you want to get paid?! :-P18:46
nowenAccentureDan: yes, I did.  And i do.18:47
AccentureDannow we need hte licenses :-P18:47
AccentureDanclose to production time here sir!18:47
nowenI've been working from home though and need to get to the office to fax it18:47
AccentureDanstep on it! :-P18:47
nowenAccentureDan: no worries, we track it via your Certificate.18:47
AccentureDanawesome!18:47
AccentureDanjust so you know, we are deploying in about a week or two, just want to make sure there will be no issues18:49
AccentureDanwhen we go to set people up and register18:49
AccentureDan:-D18:49
nowenyou should be good18:49
AccentureDanany confirmation you can send our way would help man18:49
AccentureDanthanks a bunch!18:49
nowenTXRH_CJ: ok - so, I can create an entry for IP Address 1 and point it to  wikid.txrh.com18:50
nowenTXRH_CJ: however, auth.txrh.com is better - leaks less intel.18:50
TXRH_CJlets go with auth18:51
nowenok - what is ip address 1?18:51
TXRH_CJ216.248.45.18218:51
*** zgur (d8398471@gateway/web/freenode/ip.216.57.132.113) has joined #wikid18:52
TXRH_CJauth.texasroadhouse.com is what we want18:52
nowenok - so your domain id is 216248045182?18:52
TXRH_CJnot txrh, and yes that is the id18:53
*** AccentureDan has quit (Ping timeout: 240 seconds)18:53
nowenTXRH_CJ: ok - done18:54
zgurnew to wikid, need to install the client - server has been installed by someone else and is working.18:55
TXRH_CJwhat is needed on the client side?18:55
nowenTXRH_CJ: nothing18:55
zgurgetting the following error in the log18:55
zgurSending 384 bytes of post data from pullConfig un-encoded data length:384 encoded data length:518 un-encoded data length:384 encoded data length:518 encoded data length:4 un-encoded data length:1  Response data contents (base64 encoded) <<NA==>> Returning decoded data ... (1 bytes) Read 1 bytes from the server Invalid Server Response18:55
zgurtrying to "pre-register domain"18:56
nowenzgur: that's the error on the server side?18:56
nowenzgur: did you upload the pre-reg data?18:57
zgurthat's what i see on the client side after enabling debugging18:57
nowendid your server admin give you a pre-reg secre?18:57
nowensecret?18:57
zguryes18:57
nowenand that secret is also uploaded on the server side?18:58
zgurthat's unknown ton to me but presumably yes18:58
nowenwhat happens when you try to add the domain without pre-reg?18:59
zguradmin is in the different time zone  so cannot talk to him directly18:59
zguryou mean create a domain ?18:59
nowenyes19:00
zgurgot registration successfull and a code of some sort19:01
nowenzgur: well, I'm guessing there's something wrong with the pre-reg code19:01
nowenzgur: are you part of a testing team?19:02
zgurwhy would server reply be invalid , instead of some sort of an error, indicating pre-reg issue19:02
nowennot sure about that.19:03
nowenusually an error like that means there's something between the server and the client19:03
zgurok, thank you for your help19:04
zgurno i'm not a part of the testing team. I'm just a user who needs access19:06
nowenwell, if you can get in touch with Admin and send him the reg code you just got, you should be good19:07
nowenhave the admin contact us and we can help see what's going on19:07
TXRH_CJok, thanks Nick, we will be testing this weekend19:08
nowenTXRH_CJ: ok19:08
nowenlet me know19:09
*** TXRH_CJ has quit (Ping timeout: 240 seconds)19:13
nowenzgur: what company are you with?19:22
zgurAngel19:26
nowenahh19:27
nowenok, I know your admin, at least one19:27
zgurMariusz ?19:28
nowenSarah19:28
zgurAha  Mariusz is online , so hopefully he will be able to figure it out19:36
nowenok19:36
zgurAgain, thanks for your help19:36
nowenhe should see the successful reg you did19:36
*** zgur has quit (Quit: Page closed)19:55
*** nowen has quit (Quit: Leaving.)22:38

Generated by irclog2html.py 2.11.0 by Marius Gedminas - find it at mg.pov.lt!